Ibm Fan Canister Status Test

This test reports the current status of each fan canister in the enclosure.

Target of the test : An IBM DS Raid Storage device

Agent deploying the test : A remote agent

Outputs of the test : One set of results for each fan canister in the enclosure

Configurable parameters for the test
Parameter	Description
Test Period	How often should the test be executed .
Host	The IP address of the storage device
Port	The port number at which the specified Host listens. By default, this is NULL.
SMCliLocation	The test uses the command-line utility, SMcli.exe, to collect the required statistics from the IBM DS Raid Storage device. To enable the test to run the SMcli.exe, provide the full path to the exe in the SMCliLocation text box. Note: If the SMcli.exe resides in say, C:\Program Files\IBM_DS\client, your SMCliLocation should be : C:\Progra~1\IBM_DS\client. On the other hand, if the SMcli.exe resides in say, C:\Program Files (x86)\IBM_DS\client, your SMCliLocation should be: C:\Progra~2\IBM_DS\client.
Alternate Controller IP	By default, the Alternate Controller IP text box is set to none. This implies that by default, the storage device being monitored supports a single controller only, and the IP address of this controller is the same as the IP address of the target Host. Sometimes, a storage device could be configured with two/more controllers, so as to provide fail-over services - in other words, if the primary controller is down, then one of the alternate controllers will take over from the primary to provide the critical storage services. In this case, you can provide a comma-separated list of alternate controller IPs in the Alternate Controller IP text box.
Timeout	Indicate the duration (in seconds) for which this test should wait for a response from the storage device. By default, this is set to 30 seconds.

Measurements made by the test

Measurement

Description

Measurement Unit

Interpretation

Canister status

Indicates the current status of this fan canister.

The values that this measure can report and the numeric values that correspond to them are listed below:

Measure Value	Numeric Value
Optimal	1
Online	2
Degraded	3
Failed	4
Offline	5
Unknown	6

Note:

This measure reports the Measure Values listed in the table above to indicate the current state of a fan canister. However, in the graph of this measure, the state is indicated using only the Numeric Values listed in the above table.